Products » Rigging Equipment » Outrigger Beams » 5x5 Outrigger Beam » Splice Tube, 8ft

Splice Tube, 8ft

Create an extended outreach of up to 8 ft using our existing 5x5 H-beam system, while keeping installation as easy and safe as possible.

The Cable Truss Assembly has been used in the industry for a long time, but it is frequently over tightened, or otherwise not installed correctly (don’t use 2 ft splice tubes) which could lead to rollover failures. Below is a link to an article discussing the right and wrong way to install the Cable Truss.

By using the 8 ft splice tube instead, we eliminate the need for a cable truss system and along with it, confusion on the proper parts to use and tension needed on the cable truss. The beam with splice tube(s) is assembled with quick pins and no manual adjustments are required. This virtually eliminates mistakes and makes installation easier, safer and faster.

1.We recommend using a 3 ft splice tube (#920183) to connect the middle beam to the rear to keep the bowing of the beam to a minimum.
2.When used in combination with our Rolling Outrigger Beam, a slightly bigger front mast head is required to accept the 8 ft splice tube (#920205).

For a more information see the pdf links below.
> Drawing - Splice Tube, 8 ft
> Drawing - 24ft Rolling Outrigger with 8ft Splice Tube
> Article - Cable Truss System on Outrigger Beams

Splice Tube, 8ft
Part Number: 920176

Join Our Newsletter

Bee Access Products
2145 Indian Road
West Palm Beach, FL 33409

Toll Free   888.616.9003
Phone   561.616.9003
Fax   561.616.9005

© 2018 Bee Access Products - All Rights Reserved. Privacy Policy
Website Design by IWD Marketing